Instructions for Use

To clean, rinse, disinfect and remove protein daily, these ‘rub and rinse’ steps must be completed:
Preparations:

• Remove safety ring under screw cap.
• Do not use if seal is broken, damaged or missing at time of purchase.
• To open bottle; turn screw cap (containing sharp pin) clockwise to break seal.
• Wash and clean hands before handling contact lenses.

Rub and Rinse Directions are for all contact lens replacement schedules.
Step 1: Cleaning and Protein Removal – Completely soak the contact lens with AquaRefresh™ Multipurpose Solution. Rub lens in the palm of your hand using the forefinger of the other hand for approximately 20 seconds. Be sure to clean both sides. No separate daily cleaner necessary.
Step 2: Rinsing – Thoroughly rinse each side of each lens for 10 seconds with AquaRefresh™ Multipurpose Solution to remove all debris.
Step 3: Disinfection and Storage – Fill your contact lens case with AquaRefresh™ Multipurpose Solution and place lenses in the correct side. Close case and tighten. Allow lenses to soak at least 4 hours.
Your lenses are now ready to wear. No saline rinse is necessary. If any debris remains on contact lenses, rinse with AquaRefresh™ Multipurpose Contact Lens Solution. Always follow your Eyecare professional’s instructions. Based on your individual tear chemistry and lens-wearing schedule, your Eyecare professional may recommend
the use of a separate enzymatic cleaner before step 1.
Storage: Using a clean case, completely submerge your lenses in AquaRefresh™ Multipurpose Contact Lens Solution to store them. Lenses may be stored in the unopened case until ready to wear, up to a maximum of 30 days. If you store your lenses for longer periods of time, they must be cleaned and disinfected with fresh AquaRefresh™ Multipurpose Contact Lens Solution every 30 days prior to wearing.
Protein Removal: AquaRefresh™ Multipurpose Contact Lens Solution removes protein from your contact lenses while you clean and disinfect your lenses daily.